Description
Features:
Brand new pickup/pulsar coil for you to repair your stator.
Direct replacement for your original device.
Plug-and-play, direct fit, easy installation.
Often not available from the OEM manufacturer.
All shipped products are tested.
Special features:
Condition: Aftermarket 100% brand new
Quantity: 1 PC
Type: Pulsar coil
Mass:
Height: 17.6 mm
Length: 26 mm
Width: 22 mm
Mounting distance from center to center: 33.7 mm
Other specifications:
Number of wires: 2
PART NUMBERS):
28458-G01
26651-G02
Equipment:
1991-2003 For EZGO Gas 4 Cycle ForGolf Cart Model with For Robins 295cc/350cc
(For pre-MCI models only)
Package:
1x Pulsar coil
Note:
Failure to follow these instructions may result in damage to the part or other components on your vehicle.
- Solder the wires to those of your OEM wiring harness using a small soldering iron.
-Insulate your solder joints with heat shrink tubing.
-Before attempting to start your vehicle, the air gap must be adjusted on certain models.
- Rotate the flywheel by hand so that the raised node is aligned with the pickup/pulsar coil, and adjust it as close as possible but not less than 0.010 inches.
-If no spark or irregular spark occurs, swap the wires at the connector.
Guarantee:
Returns: Customers have the right to request a return within 60 days of receiving the product.
24-hour online expert: Solve your installation and product problems
Brand new pickup/pulsar coil for you to repair your stator.
Direct replacement for your original device.
Plug-and-play, direct fit, easy installation.
Often not available from the OEM manufacturer.
All shipped products are tested.
Condition: Aftermarket 100% brand new
Quantity: 1 PC
Type: Pulsar coil
Mass:
Height: 17.6 mm
Length: 26 mm
Width: 22 mm
Mounting distance from center to center: 33.7 mm
Other specifications:
Number of wires: 2
PART NUMBERS):
28458-G01
26651-G02
Equipment:
1991-2003 For EZGO Gas 4 Cycle ForGolf Cart Model with For Robins 295cc/350cc
(For pre-MCI models only)
Package:
1x Pulsar coil
Note:
Failure to follow these instructions may result in damage to the part or other components on your vehicle.
- Solder the wires to those of your OEM wiring harness using a small soldering iron.
-Insulate your solder joints with heat shrink tubing.
-Before attempting to start your vehicle, the air gap must be adjusted on certain models.
- Rotate the flywheel by hand so that the raised node is aligned with the pickup/pulsar coil, and adjust it as close as possible but not less than 0.010 inches.
-If no spark or irregular spark occurs, swap the wires at the connector.
Guarantee:
Returns: Customers have the right to request a return within 60 days of receiving the product.
24-hour online expert: Solve your installation and product problems
