PIP-up Pulsar Coil Fit for Beta RR 2T 125 250 300 13-18 4t 350 450 480 10-18

Pulse sensor/heart rate sensor suitable for Beta RR 2T 125 250 300 4T 350 390 400 430 450 498 520

Characteristics:
Brand new pickup/pulsar coil for repairing your stator.
Direct replacement for your original device.
Plug-and-play, direct fit, easy installation.
Often not available from the OEM manufacturer.
All shipped products are tested.

Specifications:
Condition: Aftermarket 100% brand new
Quantity: 1 PC
Type: Pulsar coil

Mass:
Height: 18 mm
Length: 26 mm
Width: 22.3 mm
Mounting distance from center to center: 35 mm

Other specifications:
Number of wires: 2
Number of plugs: 1
Number of pens: 2

PART NUMBERS:
026100030000
006100300000

Equipment:
Suitable for Beta Xtrainer 2015-2018
Suitable for Beta RR 2T 125 2018
Suitable for Beta RR 2T 250 2013-2018
Suitable for Beta RR 2T 300 2013-2018
Suitable for Beta RR 2T 250 Racing 2014-2018
Suitable for Beta RR 2T 300 Racing 2013-2018

Suitable for Beta RR 4T Factory 2012
Suitable for Beta RR 4T 400 Factory 2011
Suitable for Beta RR 4T 450 Factory 2011
Suitable for Beta RR 4T 520 Factory 2011
Suitable for Beta RR 4T 350 Factory 2014
Suitable for Beta RR 4T Cross Country 2012
Suitable for Beta RR 4T 350 EFI 2015
Suitable for Beta RR 4T 350 2011-2018
Suitable for Beta RR 4T 390 2014-2018
Suitable for Beta RR 4T 400 2010-2013
Suitable for Beta RR 4T 430 2014-2018
Suitable for Beta RR 4T 450 2010-2013
Suitable for Beta RR 4T 480 2014-2018
Suitable for Beta RR 4T 498 2012-2013
Suitable for Beta RR 4T 520 2010-2011
Suitable for Beta RR 4T 350 Racing 2013/2015-2018
Suitable for Beta RR 4T 430 Racing 2015-2018
Suitable for Beta RR 4T 450 Racing 2013-2014
Suitable for Beta RR 4T 480 Racing 2015-2018
Suitable for Beta RR 4T 498 Racing 2014

Package contents:
1x Pulsar coil

(The compatibility table is for reference only!!!)
(Please compare your faulty device with the image we provided to help you decide on the equipment.)

A NOTICE:
Failure to follow these instructions may result in damage to the part or other components of your vehicle.
- Use a small soldering iron to solder the wires to the cables of your OEM wiring harness.
- Insulate your solder joints with heat shrink tubing.
- Before attempting to start your vehicle, you may need to adjust the air gap on certain models.
- Rotate the flywheel by hand so that the raised node is aligned with the pickup/pulsar coil, and adjust it as close as possible but not less than 0.010 inches.
-If there is no spark or an irregular spark, switch the wires at the plug.