Description
Features:
Brand new pickup/pulsar coil for you to repair your stator.
Direct replacement for your original device.
Plug-and-play, direct fit, easy installation.
Often not available from the OEM manufacturer.
All shipped products are tested.
Special features:
Condition: 100% brand new
Quantity: 1 piece
Type: Pulsar coil
Mass:
Height: 19 mm
Length: 26mm
Width: 21 mm
Mounting bracket center to center: 35 mm
Cable length: approx. 870 mm
Other specifications:
Number of wires: 2
Number of plugs: 1
Number of pens: 2
Part number (P/N):
21003-0074
Equipment:
For Kawasaki EX250 Ninja 250R 2008-2012
Package:
Pick up 1 x Pulsar coil
Note:
Failure to follow these instructions may result in damage to the part or other components on your vehicle.
- Solder the wires to those of your OEM wiring harness using a small soldering iron.
-Insulate your solder joints with heat shrink tubing.
-Before attempting to start your vehicle, the air gap must be adjusted on certain models.
- Rotate the flywheel by hand so that the raised node is aligned with the pickup/pulsar coil, and adjust it as close as possible but not less than 0.010 inches.
-If no spark or irregular spark occurs, swap the wires at the connector.
Guarantee:
Returns: Customers have the right to request a return within 60 days of receiving the product.
24-hour online expert: Solve your installation and product problems
Brand new pickup/pulsar coil for you to repair your stator.
Direct replacement for your original device.
Plug-and-play, direct fit, easy installation.
Often not available from the OEM manufacturer.
All shipped products are tested.
Special features:
Condition: 100% brand new
Quantity: 1 piece
Type: Pulsar coil
Mass:
Height: 19 mm
Length: 26mm
Width: 21 mm
Mounting bracket center to center: 35 mm
Cable length: approx. 870 mm
Other specifications:
Number of wires: 2
Number of plugs: 1
Number of pens: 2
Part number (P/N):
21003-0074
For Kawasaki EX250 Ninja 250R 2008-2012
Package:
Pick up 1 x Pulsar coil
Note:
Failure to follow these instructions may result in damage to the part or other components on your vehicle.
- Solder the wires to those of your OEM wiring harness using a small soldering iron.
-Insulate your solder joints with heat shrink tubing.
-Before attempting to start your vehicle, the air gap must be adjusted on certain models.
- Rotate the flywheel by hand so that the raised node is aligned with the pickup/pulsar coil, and adjust it as close as possible but not less than 0.010 inches.
-If no spark or irregular spark occurs, swap the wires at the connector.
Guarantee:
Returns: Customers have the right to request a return within 60 days of receiving the product.
24-hour online expert: Solve your installation and product problems
