Description
Features:
Brand new pickup/pulsar coil for you to repair your stator.
Direct replacement for your original device.
Plug-and-play, direct fit, easy installation.
Often not available from the OEM manufacturer.
All shipped products are tested.
Specifications:
Condition: Aftermarket 100% brand new
Quantity: 1 PC
Type: Pulsar coil
Mass:
Height: 17mm
Length: 31 mm
Width: 30 mm
Mounting distance from center to center: 50 mm
Other specifications:
Number of wires: 2
Part number:
30300-MBZ-610
30300-MBZ-611
30300-MFJ-D01
30300-MV9-671
30300-MW0-000
30300-MW0-003
30300-MBW-610
30300-MBW-J21
30300-MCJ-000
30300-MCJ-750
Equipment:
Suitable for Honda CBF600N (naked) PC38 2004–2006
Suitable for Honda CBF600S PC38 2004–2006
Suitable for Honda CB600F Hornet 600 1998
Suitable for Honda CB600F Hornet 1999–2006
Suitable for Honda CB600F21 Hornet S 2001
Suitable for Honda CB600F22 Hornet S 2000-2002
Suitable for Honda CBR600F2 1991-1994
Suitable for Honda CBR600F3 1995-1998
Suitable for Honda CBR600F Smokin' Joe's Edition 1996-1998
Suitable for Honda CBR600F FS FT FW FV 1995–1998
Suitable for Honda CBR600F FY FX 1999–2000
Suitable for Honda CBR600 CBR600F4 1999-2000
Suitable for Honda CBR600 CBR600F4I 2001-2006
Suitable for Honda CBR600RR (ABS) 2009-2020
Suitable for Honda CBR600RR 2007-2020
Suitable for Honda CBR900RR CBR919RR Fireblade 1996-1999
Suitable for Honda CBR900RR Fireblade 1992-1995
Suitable for Honda CBR900RR CBR929RR Fireblade 2000-2001
Suitable for Honda CBR900RR CBR954RR Fireblade 2002-2003
Suitable for Honda CBR1000RR Fireblade CBR1000RR8 2008
Suitable for Honda CBR1000RR Fireblade CBR1000RR9 2009
Suitable for Honda CBR1000RR Fireblade 2010-2013
Suitable for Honda CBR1000RR ABS Fireblade CBR1000RA9 2009
Suitable for Honda CBR1000RR ABS Fireblade CBR1000RA 2010-2016
Suitable for Honda CBR1000RR 2014-2019
Suitable for Honda CBR1000RA 2017-2019
Suitable for Honda CBR1000S 2014-2019
Package contents:
1x Pulsar coil
A NOTICE:
Failure to follow these instructions may result in damage to the part or other components on your vehicle.
- Solder the wires to those of your OEM wiring harness using a small soldering iron.
-Insulate your solder joints with heat shrink tubing.
-Before attempting to start your vehicle, the air gap must be adjusted on certain models.
- Rotate the flywheel by hand so that the raised node is aligned with the pickup/pulsar coil, and adjust it as close as possible but not less than 0.010 inches.
-If no spark or irregular spark occurs, swap the wires at the connector.
